Table of Contents
Advertisement
Installation
Figure 2-1: Login Screen
Setup Wizard and Authentication
Step 1 - Change Password
Step 2 - Device Time
4. In the Password field, type the password (default is motorola).
5. Click Login.
6. First time users see a pop-up box that states: "The Wizard application will guide
you through for the first time configuration". Click OK button to continue.
7. Click the OK button to launch the wizard application.
Once you have launched the setup wizard, you are prompted to change your password.
Motorola recommends using a password to protect your home network and CPE
device. Passwords are case sensitive.
To change your password:
• Ensure the "Enable Login Password Protection" box is checked.
• Enter a New Login Password in the box. Passwords can be no more than 20
characters in length.
• Re-type your new password in the Confirm New Login Password box.
• Click Next.
If you forget your password, you can reset it back to the default (motorola) password.
To reset the password, press and hold the reset button on the back of your CPE for 5 or
more seconds. Before resetting the CPE, ensure that the power is ON.
This screen allows you to set the time zone and to enable Daylight Savings Time (when
applicable) for your location.
• Select the appropriate time zone for your location from the drop-down box.
2
Advertisement
Table of Contents
