Toshiba 42WL863B Owner's Manual page 100

PROBLEM SOLVING
Q
What is DVB-T?
A
Digital Video Broadcast via an aerial/antenna.
Q
What is DVB-C?
A
Digital Video Broadcast via a cable connection.
Q
How are radio channels selected?
A
Press TV on the remote control and select DTV
Radio. Alternatively select from the GUIDE.
Q
What can be done if the PIN number has been
forgotten?
A
Use the Master PIN code of 1276, then change to a
number of your choice. Select Parental PIN Setup
from the DTV Settings menu to enter PIN. Ensure
that no-one else can use the Master PIN by removing
the Owner's Manual.
Q
Why are there vertical stripes on the screen when
in PC mode?
A
The Sampling Clock may need adjustment. Select PC
Settings from the Display Settings menu, highlight
Sampling Clock and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
The Clock Phase may need adjustment. Select PC
Settings from the Display Settings menu, highlight
Clock Phase and adjust until the picture clears.
Q
Why when digital subtitles have been selected are
they not showing on screen?
A
Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the main index page of the text service
and look for the User Guide. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text see the text section.
Q
Why is a page number visible at the top of the
screen but no text?
A
Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the colours wrong when an NTSC source
is played?
A
Connect the source via a SCART lead and play.
Select Colour System from the System Setup menu.
a
Set the Colour to Auto and exit.
b
Go to the Picture menu and adjust the tint.
Q
Why don't the devices connected via HDMI
operate properly?
A
Make sure to use cables with the HDMI logo
(see page 13).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new
standard adoption. Try switching the HDMI settings
(Enable Content Type and INSTAPORT™) to Off.
Q
Why don't the devices connected via MHL operate
properly?
A
Turn off your TV and unplug the power cord, and then
plug and turn on again.
Turn the MHL Source Power Off and On again.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed the settings of
the device, turn off your television and unplug the
power cord, and then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device
and lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK device is disconnected, the logo
will disappear after approximately one minute.
Q
Why don't the networked devices work?
A
The LAN cables are not connected properly or at all.
Connect all cables (see page 16).
Make sure your network address is set up correctly
(see page 51).
100