Logik LHFDAB14 - DAB Micro Hi-Fi Quick Start Guide

Introduction

Thank you for purchasing your new product.

Please follow this quick start guide for a successful first time set up. We recommend that you spend some time reading the instruction manual in order to fully understand all the operational features it offers. Read all the safety instructions carefully before use and keep the instruction manual for future reference.

Unpacking

Remove all items from the packaging. Retain the packaging.
If you dispose of it please do so according to any local regulations.

Battery Replacement

Remove the plastic strip from the battery if the battery is being used for the first time. It is located at the bottom rear of the remote control.

The remote control requires a CR2025, 3V Lithium battery.

1. Slide and hold the battery release tab in the direction of the arrow.
   
2. Pull out the battery holder and remove the old battery.
   
3. Replace with a new battery.
   
4. Insert the battery holder back into the remote control.
   

Connections

Speaker Connections

Connect the speaker cables at the back of the speakers to the SPEAKER (L/R) Sockets at the rear of the unit.

Using the AUX Connection

Use a 3.5mm to RCA stereo audio cable to connect the audio device's audio output sockets to the unit's AUX IN socket.

Use a 3.5mm to 3.5mm stereo audio cable to connect the mobile device's headphone socket to the unit's AUX IN socket.

Connecting to the Mains Supply

• This unit is designed to operate with an AC power supply.
• Connecting the unit to any other power source may cause damage to the unit. Unwind the mains cable to its full length. Connect the mains plug to a mains socket. Make sure the mains plug is fully inserted into the mains socket. The unit is now connected and ready to use.
• To switch the unit off completely, unplug the mains plug from the mains socket.

Ensure all audio connections of the unit are connected before connecting to the mains power socket.

General Operation

Powering ON/OFF

When you first connect the unit to the mains socket, the unit will be in STANDBY mode.

• Press on the unit or the remote control to switch the unit to ON mode.
• Press to switch the unit back to STANDBY mode. The Power LED indicator will light up red.
• Disconnect the mains plug from the mains socket if you want to switch the unit off completely.

• When the unit is idle for approximately 15 minutes, it will automatically switch to standby.
• Please turn the unit off completely to save energy when not in use.

Selecting Modes

Press MODE repeatedly to switch between DAB, FM, CD and AUX modes.

Adjusting the Volume

• Turn the VOLUME +/– dial on the unit or press VOLUME +/– on the remote control to adjust the volume.
• If you wish to turn the sound off, press MUTE on the remote control. Press MUTE again or press VOLUME +/– on the remote control or turn VOLUME +/– to resume normal listening.

Tip: You will find that there are many exciting features available. To get to know all these features, please take some time to read the instruction manual provided.