Logik LHFM14 Quick Start Manual

Quick Start Guide
Hi-Fi with CD Player
LHFM14
Thank you
for purchasing your new Logik Hi-Fi with CD Player.
Please follow this quick start guide for a successful rst time set up.
We recommend that you spend some time reading the instruction manual in order to fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep the instruction manual for future reference.
1 1

Unpacking

Remove all items from the packaging. Retain the packaging.
If you dispose of it please do so according to any local regulations.
Main Unit Speaker x 2h
Remote Control
(battery included)
STANDBY
Instruction Manual Quick Start Guide
Ins tru ctio n
Ma nua l
Quick Start Guide
2 2

Battery Replacement

Remove the plastic strip from the
battery if the battery is being used
for the rst time. It is located at
the bottom rear of the remote
control.
1. Press down of the compartment
cover, and slide the cover off open
the compartment. Place the one
accessory CR2032 battery in the
remote control according to the
polarity markings ("+" and "–").
Inside the compartment and on
the battery.
2. Place the cover into the
compartment, press down lightly,
and push it inside until it snaps on.
3. Close the battery compartment cover.
If the remote control is not in use for a long
periods, the battery will become weak, and the
remote control will be not functioned, please
replace with new one if above happened.
4 4

Connecting to the Mains Socket

Connect the mains cable at the rear of the main unit to the
mains socket.
To the
mains
CLASS 1
LASER PRODUCT socket
R L
SPEAKERS
PHONES
ANT
~ AC IN
T T
You will nd that there are many exciting features available.
ip: ip:
To get to know all these features, please take some time to read the instruction manual provided.
3 3

Speaker Connections

Connect the speaker cables at the back of the speakers to the
speaker sockets (L/R) at the rear side of the unit.
R L
CLASS 1
LASER PRODUCT
R L
SPEAKERS
PHONES
ANT
~ AC IN
5 5

Basic Operation

Powering ON/OFF

When you rst connect the unit to the mains socket. The unit
will be in STANDBY mode.
• Press the STANDBY Button on the unit to switch the unit on.
The LCD Display will light up after connection is normal.
• Press the STANDBY Button again to switch the unit off.
• Disconnect the mains cable from the mains socket if you
want to switch the unit off completely.

Selecting Modes

Press the RADIO/CD/MP3 Button repeatedly to switch
between modes (CD/MP3 or RAD).
RAD CD/MP3

Adjusting the Volume

Press the VOLUME +/– on the unit or VOL+/VOL– on the
remote control to increase/decrease the volume.
Press the MUTE Button on the remote control to mute the
unit. Press MUTE Button to resume.
QSG-LHFM14-140328V1