Scanning The Network - Hercules ePlug 500 Nano Manual

- Unplug the PLC adapter that you wish to add to the monitoring list, and make a note of its MAC address.
Next, enter the MAC address in the corresponding field and select (in the drop-down list) the room in which
the PLC adapter in question is set up.
- Click Add and repeat this procedure for all of the other adapters that you wish to add.
- Click when you're done.
- Plug the adapter into an electrical outlet in the room you have indicated.
- Click .
- Connect the adapter according to the instructions displayed onscreen.
- Click .
- Click Close.
The new adapter appears in the general configuration display for your PLC network.

3.3. Scanning the network

An automatic scan of the network is carried out each time you launch Hercules ePlug Station, or when you
access the General tab. You can carry out a manual scan from the General tab by clicking the Scan the
network button.
To disable automatic scanning of the network, go to the Info tab and deselect the
Automatically scan the network box.
From then on, only a manual scan will allow you to refresh the general configuration of your
PLC network.
Hercules ePlug 500 Nano
User Manual – 27/73