Changing An Adapter's Location; Changing The Password For Your Plc Network - Hercules ePlug 500 Nano Manual

Hercules ePlug 500 Nano

3.4. Changing an adapter's location

If you have unplugged an adapter to plug it in in another room in your home, you can change the location
information in ePlug Station to update the general configuration of your network.
- In the General tab, click the
- Verify that the MAC address is correct, then select the new room from the drop-down list.
- Click .

3.5. Changing the password for your PLC network

In order to communicate with each other, the adapters in your PLC network must all have the same password.
If you modify the password for an adapter or adapters in your ePlug Station network, make
sure to apply the new password to all of your adapters, by connecting them (one by one) to
your PC and following the steps set out below.
On the adapter already connected to the PC:
- In the Advanced settings tab, enter the new network password in the corresponding field.
28/73 – User Manual
icon in the upper right corner of the depiction of the room.