Table of Contents
Advertisement
Hercules ePlug 200 Mini
3.5. Scanning the network
An automatic scan of the network is carried out each time you launch Hercules ePlug Station, or when you
access the General tab. You can carry out a manual scan from the General tab by clicking the Scan the
network button.
To disable automatic scanning of the network, go to the Info tab and deselect the
Automatically scan the network box.
From then on, only a manual scan will allow you to refresh the general configuration of your
PLC network.
3.6. Changing an adapter's location
If you have unplugged an adapter to plug it in in another room in your home, you can change the location
information in ePlug Station to update the general configuration of your network.
- In the General tab, click the
- Verify that the MAC address is correct, then select the new room from the drop-down list.
- Click
.
3.7. Changing the password for your PLC network
In order to communicate with each other, the adapters in your PLC network must all have the same password.
If you modify the password for an adapter or adapters in your ePlug Station network, make
sure to apply the new password to all of your adapters, by connecting them (one by one) to
your PC and following the steps set out below.
26/59 – User Manual
icon in the upper right corner of the depiction of the room.
Advertisement
Table of Contents
