Maintenance; Problem Solution; Environmental Protection - KRESS KU124 Manual

LED light indicator
Before operation, the LED light
will be activated when the On/
Off switch is slightly pressed,
and will automatically turn off
20 seconds after the On/Off
switch is released.
The tool and battery are
equipped with a protection
system. When the LED Light
is quickly flashing 3 seconds
and turn off, the system will
automatically cut off power to
the tool to extend battery life.
The tool will automatically stop
during operation if the tool and/
or battery are placed under one
of the following conditions:
• Overloaded: The tool
is operated in a manner
that causes it to draw an
abnormally high current. In
this situation, release the
Trigger Switch on the tool
and stop the application that
caused the tool to become
overloaded. Then pull the
Trigger Switch again to
restart.
• Overheated: Under the
condition above, if the tool
does not start, the Tool and
Battery are overheated. In
this situation, let the Tool and
Battery cool before pulling
the Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity
is too low and the tool will
not operate. In this situation,
remove and recharge the
Battery.
WARNING! To turn on
the light, press the On/
Off switch and make sure the
Forward/Reverse Rotation
Control is on right/left position.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward and Reverse Switch, which is on top of
the trigger, is positioned in the lock function. Unlock the
Forward and Reverse Switch putting it into the required
rotation position. Push the trigger and the drill will start
to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the Torque Adjustment
Ring, you can find the Torque Adjustment Ring between
the Chuck and the drill body. Position 1 is the lowest
torque (screw driving force) and position 18 is the
highest torque (screw driving force). Position is for drill
operation. Regulate the Torque Adjustment Ring to a
higher position to reach the best result.
3. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED Light should turn on when the
battery is charging.
4. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not used
a Battery Pack for a prolonged time will reduce the
Battery Pack working time. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such
as large screws into hard wood will use up the Battery
Pack energy faster than lighter working conditions. Do
not re-charge your Battery Pack below 0
40 C as this will affect performance.
o

MAINTENANCE

Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use
and storage is 0 C-45 C.
o o
The recommended ambient temperature range for the
charging system during charging is 0
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted for
environmentally friendly recycling.
The plastic components are labeled for categorized
recycling.
C and above
o
11
EN
C-40 C.
o o