Cobalt Digital Inc 9934-AUD-PRO Product Manual page 80

3
Table 3-2 9934-AUD-PRO Function Menu List — continued
Note: •
AES Out Ch 2 has controls identical to the Source, Gain, Mute, and Invert controls described here for AES Out
Ch 1. Therefore, only the AES Out Ch 1 controls are shown here.
•
For each channel, its source and destination should be considered and appropriately set. Unused destination
channels should be set to the Silence selection.
• AES Output Channel Source
• Channel Mute/Phase Invert/Gain Controls
and Peak Level Display
3-40
9934-AUD-PRO Function Menu List and Descriptions
Provides an audio crosspoint allowing the audio source
selection for each AES audio output channel. Also
provides Gain, Phase Invert, and Muting controls and
peak level meters for each output channel.
Using the Source drop-down list, selects the audio input source to be
routed to the corresponding AES output channel from the following
choices:
• Card Audio Bus Ch 1 thru Ch 16
• Built-in Tone generators Tone n
(-20 dBFS level tone generators with n being frequencies of 100, 200,
300, 400, 500, 600, 700, 800, 900, 1k, 2k, 4k, 6k, 8k, 12k, and 16k)
• Flex Bus A thru P mixer sum node outputs
• Audio LTC
• Downmixer L
• Downmixer R
• Embedded Data L and R (SMPTE 337 non-PCM data
embedding with option +ANC)
• Audio DSP n sources (route DSP output to card AES output)
Note: • Audio DSP source choices depend on Audio DSP asset(s) being
enabled and position at output mixer (see Audio DSP Setup
Controls (p. 3-11) for more information).
• AES pair channel count are dependent on rear I/O module used.
Current rear modules may not support full output complement.
Provides Mute and phase Invert channel controls, as well as peak level
meter for each output channel. (Meter shows level as affected by Level
control.)
Gain controls allow relative gain (in dB) control for the corresponding
destination AES output channel.
(-80 to +20 dB range in 1.0 dB steps; unity = 0 dB)
Note: Although the 9934-AUD-PRO can pass non-PCM data such as
®
Dolby E or AC-3, setting the gain control to any setting other than
default 0 will corrupt Dolby data.
9934-AUD-PRO PRODUCT MANUAL 9934-AUDPRO-OM (V1.1)