Cobalt Digital Inc 9934-AUD-PRO Product Manual page 33

Installation and Setup
Table 2-1 9934-AUD-PRO Rear I/O Modules — continued
9934-AUD-PRO Rear I/O Module
RM20-9934-C
RM20-9934-D
9934-AUDPRO-OM (V1.1)
Provides the following connections:
• Four 3G/HD/SD-SDI video input BNCs (SDI IN A
thru SDI IN D)
• Four 3G/HD/SD-SDI video output BNCs
(RCK/PROC 1 thru RCK/PROC 4; each GUI
selectable as processed out, selected-input
reclocked, or wings/key-fill preview where
available)
• One relay-protected SDI processed output BNC
(RLY BYP B; outputs a copy of SDI OUT 1 under
normal conditions, or passive outputs the SDI input
on SDI IN B as a relay failover if card power is lost)
• COMM/GPIO RJ-45 connector
Note: Refer to GPIO, Serial (COMM), and Analog
Audio Connections (p. 2-10) for connector
pinouts and important information regarding
GPO electrical limits.
1914
Provides the following connections:
• Two 3G/HD/SD-SDI video inputs (VIDEO IN A and
VIDEO IN B)
• One CVBS video input (CVBS IN)
• Two analog balanced audio inputs (AN-AUD IN 1
and AN-AUD IN 2)
• Eight AES audio inputs (AES IN 1 thru AES IN 8)
• Two 3G/HD/SD-SDI video outputs (VIDEO OUT 1
and VIDEO OUT 2)
• One CVBS video output (CVBS OUT)
• Two analog balanced audio outputs
(AN-AUD OUT 1 and AN-AUD OUT 2)
• Eight AES audio outputs (AES OUT 1 thru
AES OUT 8)
Note: Available equipped with High-Density BNC
(HDBNC) or DIN1.0/2.3 connectors as:
RM20-9934-AUD-PRO-D-HDBNC or
RM20-9934-AUD-PRO-D-DIN, respectively.
1929D
9934-AUD-PRO PRODUCT MANUAL
Installing a Rear I/O Module
Description
2-5