Table of Contents
Advertisement
INSTALLING
POWER SUPPLY KIT M119046
INSTALLATION INSTRUCTIONS FOR MODELS:
AC2030TNA / TG2030TN
NOTE: Be sure to follow national electrical code, ANSI/
NFPA 70, or Canadian Electrical Code, Part I, CSA C221
and all local codes for electrical wiring when following
these instructions. Keep power wires away from any hot
surfaces on the furnace. Any cuts, drills or notches made
to any studs or joists must be approved per local codes.
INSTALLING THE POWER SUPPLY KIT:
1. Locate and temporarily free the control module by
unscrewing it from the heat shield.
2. Find the power socket on the control module.
NOTE: Do not allow any wiring to contact the gas line. See
local codes for gas lines and electrical wiring for more info.
3. Place the power cable through the hole on the bottom of
the bracket and clip the new strain relief onto it.
4. Plug the power cable into the control module, then secure
the strain relief to the bracket.
5. Reinstall the control module and make sure all wires are
properly secured and in place.
6. Plug power cable into the nearest outlet.
7. Turn on control module when ready to fire up.
30
CARMEL
TM
AC2030TNA TOP VENT GAS WALL HEATER
REPLACEMENT PARTS TABLE
REFERENCE #
ITEM NUMBER
1
P323856
2
P012900
1
DESCRIPTION
QUANTITY
AC power adapter
1
1/2 in. strain relief
1
2
Advertisement
Table of Contents
