Table of Contents
Advertisement
Installation Electrical
Connecting Module Power and
Control Wires
Connections are typically made at the power distribution
panel of each module.
WARNING
Proper Field Wiring and Grounding
Required!
Failure to follow code could result in death or serious
injury.
All field wiring MUST be performed by qualified
personnel. Improperly installed and grounded field
wiring poses FIRE and ELECTROCUTION hazards. To
avoid these hazards, you MUST follow requirements
for field wiring installation and grounding as
described in NEC and your local/state/national
electrical codes.
ARTC-SVX007A-EN
Module Main Power
Each module in the bank must be fed by its own individual
power. All power wiring, up to the power panel, is the
responsibility of the installing contractor.
Module Control Wiring
Every module needs to be daisy-chained together on the
CAN network. Both ends of the network need end
termination (jumper) installed. This work is the
responsibility of the installing contractor.
BMS Wiring
The physical medium will be determined by project
parameters and is the responsibility of the installing
contractor.
15
Advertisement
Table of Contents
