Table of Contents
Advertisement
Chapter 3
The Call Announce Intercom
operates in one of two modes,
two-way or one-way intercom.
Two-way intercom immediately
activates the speaker and
microphone of the called digital
set, allowing two-way
communication. One-way
intercom activates only the
speaker, leaving the microphone
of the recipient's digital set turned
off in the interest of privacy. The
recipient must press the MIC-OFF
button to respond to the call
screener.
Call Announce Intercom allows
you to specify which call buttons
are activated by Call Announce
Intercom Call Screeners, and
allows you to select up to three
Call Screeners.
Note: Call Announce Intercom is
distinct from Network (Switch
provided) intercom.
Ringer Always On
The Call Announce feature
utilizes a Ringer Always On mode.
Ringer Always On sends a tone
to users each time a Call Screener
activates Call Announce Intercom
(regardless of the ringer mode).
Get other manuals https://www.bkmanuals.com
( SRS -1050 Local Features
When using network based
intercom, only the one or two
dialed digits are presented, not
the screeners phone number. You
could also eliminate dialing
entirely with dedicated intercom,
another network-based feature.
Figure 3-1 shows a typical
application of Call Announce
Intercom.
Call Screeners
í
Directory Numbers Call Announce
9199263110
Activating Directory
9199263111
Number =
919*926*3112
9199263112* Intercom mode
way or 2-way
*Designated for intercom
Figure 3-1: Call Announce
Intercom Application
This section describes the
requirements for setting up Call
Announce Intercom followed by
the procedures to use Call
Announce Intercom to announce
a call.
Call Recipient
Intercom setup:
=
1-
Page 3-17
Advertisement
Table of Contents
