Table of Contents
Advertisement
Chapter 2
b. Retrieve the original call, if it
was held, by pressing its
red-flashing Call
Appearance button.
4. If your call is answered,
converse with the called party.
(If the MIC-OFF LED is red, the
microphone has been turned off.
Press MIC-OFF to turn it back
on.)
You can turn off the microphone
by pressing the MIC-OFF
button; its LED will turn red. No
sound will then be transmitted
to the called party, allowing you
to have a private conversation
with others in the room. To turn
the microphone back on, press
MIC-OFF again; its red LED will
go dark.
5. When the conversation is over,
hang up by pressing the
SPEAKER button.
You can pick up the call you were
originally talking on, if it was held,
by pressing the button next to its
red-flashing Call Appearance.
Note: Onhook dialing. In place
of steps 1 and 2, you can dial
the number first and then
press SPEAKER. The phone
automatically dials the
number. The number you
enter remains available for
dialing for about three
minutes.
Get other manuals https://www.bkmanuals.com
( SRS -1050 Voice Features
You can also use a one-touch
button, after handling the
existing call. This
automatically selects
handsfree operation on an idle
CA and dials the number.
Skip step 2.
(See also "Handsfree, Handset,
and Headset Modes", in Chapter
3, "Local Features".)
Receiving Handsfree Calls
A handsfree call uses the
integrated microphone and
speaker instead of the handset.
An incoming call makes the
phone ring and the Call
Appearance's LED flash green.
If you are not talking on
another call
1. Press SPEAKER and, if
necessary, the green-flashing
Call Appearance button.
2. Converse with the calling party.
(If the MIC-OFF LED is red, the
microphone has been turned off.
Press MIC-OFF to turn it back
on.)
You can turn off the microphone
by pressing the MIC-OFF
button; its LED will turn red. No
sound will then be transmitted
to the called party, allowing you
to have a private conversation
with others in the room.
Page 2-7
Advertisement
Table of Contents
