Table of Contents
Advertisement
SRS -1050 Installation (
If you do not assign a DCA, the
SRS-1050 will automatically select
a default call button.
1. To manually assign the
Designated Call Appearance
key for your SRS-1050, press 9,
ENTER to view the following
display:
DESIGNATED CA MODE
SELECT ASSIGN KEY
2.
Press the selected Multi-
assign key.
DESIGNATED CA REGISTRATION
DSGN CA = ON
3. Press ENTER. The following
display is shown. You have the
option to turn the selected key
ON or OFF.
1:ON
2:OFF
SELECT ITEM (1-2)
4. Press 1 or 2 to change the
current status, or press ENTER
to accept the current status.
DSGN CA=ON
COMPLETED
Page B-20
(1)
(1)
Get other manuals https://www.bkmanuals.com
Note: If an invalid key is
selected for the Designated
Call Appearance, the
following display is shown.
DESIGNATED CA REGISTRATION
INVALID SELECTION
PROGRAMMING AND
LABELING THE SET
Refer to Chapter 3 for procedures
to:
• Enable headset use and turn off
handsfree mode, if desired.
• Set operating parameters such
as ringer volume and tone.
• Program the calendar/clock and
other local features.
To label the buttons on the set,
you must first remove the plastic
cover over the front panel. Insert
a pointed object into the semi-
circular notch at the bottom
middle of the plastic cover and lift
the cover upward.
Below the cover is a template.
Write button labels on this
template to show the directory
numbers or features assigned to
each button. Then lay the
template back on the front panel.
Reinsert the plastic cover.
Appendix B
(XX)
Advertisement
Table of Contents
