Table of Contents
Advertisement
Appendix B
Fujitsu has developed a
DOS/Windows and a Macintosh
application file using Microsoft
EXCEL 4.0 and Excel 5.0 to assist
you in printing the templates.
These files are available for no
charge via our World Wide Web
site at
http://www.fnc.fujitsu.com.
For use with the printing
application, Fujitsu has included a
laser printer compatible paper
template in the SRS-1050 User's
Guide. As an alternative, you
may print, type, or write in the
needed designation on the
template. Additional templates
may be purchased from your
distributor or from Fujitsu.
Do not remove the perforated
display window from the template
until after printing.
All other loose materials must be
removed before placing the
template in the laser printer.
Failure to remove loose materials
may result in a paper jam in the
printer. Templates are fed via the
manual feed tray.
Please address questions about
the program to FNC TAC, at 1-
800-228-ISDN.
Get other manuals https://www.bkmanuals.com
( SRS -1050 Installation
Fujitsu Terminal Equipment
Termination Resistors (TR)
Fujitsu ISDN phones have a
Terminating Resistor (TR) switch
on the back of the set. The
options are ON and OFF.
NOTE: The default setting for
the Fujitsu TR switch is the OFF
position.
Fujitsu TR's are equivalent to 100
Ohms in the ON position. Refer
to the following discussions for
TR setting recommendations.
NT1 Settings
Termination
Many NT1's have settings
available to turn Termination ON
or OFF. If the setting is ON they
may also have settings to select
either 50 or 100 Ohms.
Sometimes these settings are
accomplished via switches, other
times they are done with jumpers.
Follow the NT1 manufacturer
instructions to set the
Termination to ON or OFF as
needed.
Timing
Page B-21
Advertisement
Table of Contents
