Getting Started - Transmitter Solutions Dolphin DOLCWIUHF-ER-902 Manual

INSTALLATION MANUAL
DOLCWIUHF-ER-902
UHF READER
12

Getting started

When the antenna installation is complete, it is necessary to determine whether the interface device must activate the
relays or simply sends, in Wiegand, the serial numbers of the tags.
Relay output: The serial numbers of the tags must be stored (see "Add Card"). the memory can hold up to 7560
cards;
Wiegand output: if the interface device is connected to an access control panel through the Wiegand bus, pairing
the cards is not necessary and therefore there is no memory limit. However, if the SELECTIVE OPERATION MODE
is set, the memorization of a single tag will affect the Wiegand communication, so only tags where the s/n has been
memorized will be allowed to pass.
Furthermore, if the installation requires the use of Erone Keeloq remote controls, which will be decoded by the built-in
receiver, the remote controls must be memorized. The memory contains 100 transmitters.
13
Programming / Navigation menu
RXU4Go
CDVI
Press button P3 for
4 seconds to enter
Programming menu
P2: scroll down
P1: scroll up
P3: confirm/enter
P4: exit
6
Menu
Select the operating output mode of the RF receiver as
Output
WIEGAND or RELAY
Add the tag s/n to the memory ( individually or by blocks )
Menu
Add Tag
Menu
Delete the tags ( single, by blocks, by list, all tags
Del Tag
Menu Add remote controls to the memory
Add Tx
Menu
Delete remote controls from the memory (can be done
individually, only one button, by blocks, by list, or all Tx )
Del Tx
Set the interval time or dead time ( see proper chapter)
Menu
Settings
Menu
Configure the operating mode of the relays and the settings of
Confi the Wiegand signal
Menu Makes a backup of the memory to an external memory device or
restores the database from an external memory device
Backup
Menu Gives information about types of outputs, No. of Tx or Tags, and
current firmware version
Info
Password
Password
Menu
Exit
EN