Transmitter Solutions Dolphin DOLCWIUHF-ER-902 Manual page 9

INSTALLATION MANUAL
DOLCWIUHF-ER-902
UHF READER
19
Del Tx
Delete RF transmitters from the memory ( single or multiple
m e n u
D e l T x
20
Single or Double Reader Architecture
The connection shown below can be done with 1 or 2 readers connected on RS-485 to the same interface unit. Each
reader is pre-programmed with a unique RS-485 address. The interface automatically assigns the right value to the
parameter "Address" The default value of this parameter is 000. During the installation, the first time a UHF card is
read, the system changes the default value assigning the address of the activated antenna.
Example 1 : Single reader configuration
124
RS-485
W a i t
D e l e t e
0 0 0 0 0 0 0 0
T x
W a i t
D e l e t e
B l o c k
0 0 0 0 0 0 0 0
P o s : 0 0 0 5
D e l e t e
L i s t 0 0 0 0 0 1 2 3
b y
C o n f i r m ?
N o
C o n f i r m ?
D e l e t e
A l l
T x N o
124
Access
control
system
W1
www.erone.com - www.cdvigroup.com
Press any button of the Tx to delete or
Type the S/N of the Tx : enter the number
using P1 or P2, shift left with P4
Press any button of the Tx to delete
Type the S/N of the Tx : enter the number
using P1 or P2, shift left with P4
Press P1 to add a Button and P2 to delete it,
confirm with P3, shift back with P4
Press P1 to scroll the list and P3 to confirm
Y e s
Y e s
Example 2 : Double reader configuration
In a double reader installation, the system assigns "Address 1" to the
parameter as the address of the first reader activated ( 250 ) and likewise
assigns "Address 2" to the parameter as the address of the second reader
activated, assigning the value 251.
250
RS-485
251
1
Access
control
system
Wiegand
W1
EN
9