Panasonic U-10MF1E8 Service Manual page 80

10. Compressor
2
(8) Place the remaining cushioning rubber onto
the new compressor at the location shown
in the figure 31.
(9) Remove the bolts which are temporarily fas-
tening the 2 pieces of cushioning rubber,
and anchor the 3 compressor legs using the
bolts, washers, and rubber washers.
(10) Insert the capillary tube assembly, as shown
in the figure 31, at the 2 brazing locations
indicated.
(11) Shape the tubes and insert them at the
remaining 2 brazing locations.
(12) Connect the manifold gauge to the high-
and low-pressure outlet ports at the outdoor
unit where the compressor was replaced.
Connect the manifold gauge to a nitrogen
cylinder and perform nitrogen gas replace-
ment.
(13) Perform copper brazing at the 4 brazing
locations.
CAUTION
In the same way as during removal, pay particular attention to protection of the
check valve shown in the figure.
An O-ring is mounted inside the oil equalizer tube connector parts. It must be
protected and do not lose it.
Front view
Fig. 30
Front view
Capillary tube assembly
2 - 36
3-WAY SYSTEM
Outdoor Unit Repair Procedures
Cushioning rubber
Bolt (Temporary mounting,
back side 2 locations,
1 piece each)
Crankcase heater
Brazing
locations (4)
Bolt
Washer: 1
Rubber washer: 1
(1 each used for 3
locations)
Cushion rubber
(remained 1 location)
Protect the oil equalizer tube
connection parts
Fig. 31