The procedures must be done by approved personnel only. The product is used for extraction of kitchen odour or air with Speak to Systemair for more information on how to install the a high moisture. product in different installation locations.
Product liability in an emergency. • Use applicable safety devices and personal protective Systemair is not liable for damages that the product causes equipment during all work on the product. in these conditions: • Before you do work on the product, stop the product and •...
capabilities, or lack of experience and knowledge, unless Transportation and they have been given supervision or instruction. storage • Do not allow children to play with the device. Warning Personal protective Make sure that the product does not equipment become damaged or wet during transportation.
To do before the installation minimum 120 mm (A). of the product Attach the product to the wall with screws. Screws for in- stallation is not supplied by Systemair. • Make sure that you have the necessary installation accessories: Note: –...
To connect the product to the Electrical connection power supply To do before the electrical The product is supplied with a 1 m cable and plug for connec- connection tion to a socket outlet. • Make sure that the electrical connection agrees with the product specification on the motor name plate.
Operation To start and stop the product If the product is used together with a cooker hood: • Start and stop the product with the cooker hood. If the product is used together with a transformer: • Start and stop the product with transformer RE 1,2. Maintenance Warning Disconnect the power by removing the plug from the power outlet before any maintenance work.
Close the fan impeller lid and fasten the locking device. • For more information about spare parts, contact technical support. Fasten the four screws on the lid. • Always use spare parts from Systemair. • To find spare parts, refer to the scannable code on the name plate.
Troubleshooting Note: If you cannot find a solution to your problem in this section, speak to Systemair technical support. Problem Cause Solution The fan impeller is not correctly Speak to Systemair technical support. balanced The fan does not operate smoothly There is dirt on the fan impeller.
Refer to the motor name plate or the technical documentation from the motor manufacturer. 11.2 Product dimensions Note: If the unit of measure is not specified, the dimensions are given in millimetres. c/c D c/c E ØF ØG Essvent S 125x2 Essvent L 125x2...
Manual 5-step transformer. Thermal fuse Accessory overview Cooker hood RE 1,2 transformer Note: The selection of accessories shown are not supplied with the product. For more information and other available accessories, refer to www.systemair.com or speak to Systemair technical support.
EU Declaration of Conformity We, the manufacturer Manufacturer Systemair Sverige AB Address Industrivägen 3 739 30 Skinnskatteberg Sweden declare under our sole responsibility that the products Machine Cupboard fan Type/Model Essvent fulfils the relevant provisions of following directives and RoHS Directive 2011/65/EU...
Need help?
Do you have a question about the Essvent S and is the answer not in the manual?
Questions and answers