BMW R 1100 S Additional Installation, Operation And Maintenance Instructions page 55

A
Number plate light
e
Attention:
Switch off the ignition before
changing a bulb.
L
Note:
Do not touch the glass of new
bulbs with the fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Make sure the ground is level
and firm and lift the motor-
cycle onto its side stand
1
2
3
Removing:
• Remove two screws 3
• Remove number plate light
• Press back the spring wire
Inserting:
– Number plate light bulb:
• Place the bulb 1 in the two
• Insert number plate light
• Tighten two screws 3 without
Changing bulbs
cover 2 downwards
clip and remove the bulb 1
12 V 5 W Sofitte
spring clips
cover 2, noting pin A
using force
2
53