Advertisement
INSTALLATION & ASSEMBLY
Saw guard assembly
b
a
Slot the guard clamping arm (d) through the pre-drilled hole in the hexagon clamp (c). Insert the hexagon
clamp (c) into the brackets hexagon recess, place the washer (b) over the hexagon clamp thread and secure
using the butterfly clamping knob (a).
NOTE: DO NOT OVERTIGHTEN otherwise you may strip the thread
b
c
e
f
d
g
CHOOSING & INSTALLING A SAW BLADE
All manuals and user guides at all-guides.com
c
a
d
It is strongly recommended that you mount the machine to a workbench or to
a purpose built stand, a pad between the scroll saw and the workbench/stand
is also recommended to reduce vibration.
Drill four 8mm holes in your workbench/stand and secure using
nuts bolts washers (Not Included).
NVR Switch assembly
A power NVR switch has
been attached to isolate the
scroll saw while not in use,
see fig A.
• Press the 'GREEN' button
to put power to the scroll
saw then press the 'ON'
button (B) to start the saw.
• Once operation has
be completed, press
the 'RED' button to isolate
the scroll saws power.
NOTE: MAKESURE THE
SPEED CONTROL DIAL (C)
IS SET TO LOW BEFORE
YOU START UP THE SAW!
8
d
c
a
d
Saw guard assembly (d) assembled
A
C
B
b
Advertisement
