Advertisement
Table of Contents
INSTRUCTION SHEET
AFBS-B600
(504971)
Cu
Ep Cu : 5-10mm
WARNING:
1.
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
www.nVent.com and from your nVent customer service representative.
2.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3.
All instructions must be completely followed to ensure proper and safe installation and performance.
4.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.
TECHNICAL SUPPORT
www.nVent.com
30-80
IP8460_A
1 OF 2
507
30-80
30-80
30-80
525 - 725
549 - 749
© 2019 nVent All Rights Reserved
0
1000 V ≈
1500 V =
50/60Hz
Advertisement
Table of Contents
Need help?
Do you have a question about the AFBS-B600 and is the answer not in the manual?
Questions and answers