Table of Contents
Advertisement
GEN
1
INFO
DISASSEMBLY AND ASSEMBLY
1. Clean parts with solvent and compressed-
air on disassembling them.
2. Oil the contact surfaces of moving parts on
assembly.
3. After assembly, check that moving parts
operate normally.
4. Install bearings with the manufacturer's
markings on the side exposed to view and
liberally oil the bearings.
CAUTION:
Do not use compressed air to spin the bear-
ings dry. This causes damage to the bearing
surfaces.
5. When installing oil seals, apply a light coat-
ing of water-resistant grease to the outside
diameter.
GENERAL INFORMATION
1-4
Advertisement
Table of Contents
