Table of Contents
Advertisement
IMPORTANT SAFETY INFORMATION
Please read this manual thoroughly before use and store in a safe place for future reference
WARNING
• Do not exceed the maximum allowable input range of any function.
• Do not apply voltage to multimeter when resistance function is selected.
• Set the function switch OFF when the multimeter is not in use.
• Set function switch to the appropriate position before measuring.
• When measuring volts do not switch to current/resistance modes.
• Do not measure current on a circuit whose voltage exceeds 240V.
• When changing ranges using the selector switch always disconnect the test leads from the
circuit under test.
• Do not exceed the maximum rated input limits
• Improper use of this multimeter can cause damage, shock, injury, or death.
Read and understand this user manual before operating the meter.
• Always remove the test leads before replacing the battery.
• Inspect the condition of the test leads and the multimeter itself for any damage before operating the
multimeter. Repair or replace any damage before use.
• Use great care when making measurements if the voltages are greater than 25VAC RMS or 35VDC.
These voltages are considered a shock hazard.
• Remove the battery if the multimeter is to be stored for long periods.
• Always discharge capacitors and remove power from the device under test before performing Diode,
Resistance or Continuity tests.
• Voltage checks on electrical outlets can be difficult and misleading because of the uncertainty of
connection to the recessed electrical contacts. Other means should be used to ensure that the
terminals are not "live".
• If the equipment is used in a manner not specified by the manufacturer, the protection provided by
the equipment may be impaired.
Advertisement
Table of Contents
