iRobot RVD-Y1 Manual page 12

Cleaning the Visual Docking
Target Sensors, IR Window, and
Charging Contacts
EN 1
Wipe sensors and charging contacts
with a clean dry cloth. You can
alternately use a pad of melamine foam
to remove built up debris on the robot
and CleanBase charging contacts.
2
Inspect the visual docking target, IR
window, and charging contacts to
make sure that they are clear of debris.
Wipe with a clean, dry cloth.
9 For more information, visit global.irobot.com
Removing Debris from Blower Cover
Inspect blower cover for any lint or debris
build-up, and wipe with a clean dry cloth
to remove.
Replacing the Bag
1
Lift up on the canister lid to open.
Important:
Do not spray
cleaning
solution or
water onto
the sensors
or sensor
openings.
2
Pull up on the plastic card to remove the
bag from the canister.
Note: This will seal
the bag so dust
and debris cannot
escape.
3
Discard the used bag.
4
Install a new bag, sliding the plastic
card into the guide rails.
5
Press down on the lid making sure that it
is completely closed.
Note: To achieve optimal performance with
your robot and automatic dirt disposal, clean
and/or replace your robot's filter as needed.