Photovoltaic Automatic Mode (Creta Silent Sol); Introduction; Installation - GENERGY CRETA SILENT RC Instructions For Use Manual

Table of Contents

Available languages

8 Photovoltaic automatic mode (CRETA SILENT SOL):

The CRETA SILENT SOL model has been specifically designed to support a solar

system in exceptional cases where solar energy is not enough. The generator is

ready to start and support the photovoltaic system, as well as stop when this

support is no longer needed. The start and stop of the generator is performed by a

contact NO (Normally Open) sent by the solar controller.

DANGER: The connection of the generator to the solar system must only be

carried out by the technician of the photovoltaic system, because it is necessary to

set parameters for start and stop the generator in the solar controller.

NOTE: This diagram below is simply for reference and is only intended to

assist in the interpretation of its operation. The user is exclusively responsible for

the installation, which must be carried out in accordance with the electrical

regulations of each country or region.

Table of Contents

Table of Contents

Creta silent sol Creta silent ats