Table of Contents
Advertisement
Chargers
D
WALT chargers require no adjustment and are designed to be as easy as possible
e
to operate.
Electrical Safety
The charger has been designed for one voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your D
WALT charger is double insulated in accordance with EN60335; therefore
e
no earth wire is required.
If the supply cord is damaged, it must be replaced only by D
service organisation.
WARNING: We recommend the use of a residual current device with a residual current
rating of 30mA or less.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal in the plug.
•
Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved
extension cable suitable for the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
When using a cable reel, always unwind the cable completely.
Battery Packs
Important Safety Instructions for All Battery Packs
When ordering replacement battery packs, be sure to include catalogue number
and voltage.
The battery pack is not fully charged out of the carton. Before using the battery pack and
charger, read the safety instructions below. Then follow charging procedures outlined.
; the maximum length is 30 m.
2
WALT or an authorised
e
English
7
Advertisement
Table of Contents
