DeWalt DCR015 Instruction Manual

DeWalt DCR015 Instruction Manual

12 v/20 v max* li-ion heavy-duty work site charger/radio
Hide thumbs Also See for DCR015:

Advertisement

INSTRUCTION MANUAL
DCR015
12 V/20 V Max* Li-Ion Heavy-Duty Work Site Charger/Radio

Advertisement

Table of Contents
loading

Summary of Contents for DeWalt DCR015

  • Page 1 INSTRUCTION MANUAL DCR015 12 V/20 V Max* Li-Ion Heavy-Duty Work Site Charger/Radio...
  • Page 2: Important Safety Instructions

    Radio 13. Unplug this apparatus during lightning storms or when unused for long periods of time. The DCR015 Heavy-Duty Work Site Charger/Radio is a combination 14. Refer all servicing to qualified service personnel. AM/FM radio and D WALT charger. The DCR015 will charge most Servicing is required when the apparatus has WALT 12 V Max* and 20 V Max* Li-Ion batteries.
  • Page 3 15. Apparatus shall not be exposed to dripping or splashing and no WARNING: To reduce the risk of fire or electric shock, do not objects filled with liquids, such as vases, shall be placed on the expose this apparatus to rain or moisture. Use only in dry locations. apparatus CAUTION: To prevent electric shock, match wide blade of plug to The lightning flash with arrow head within a triangle is intended...
  • Page 4 READ ALL INSTRUCTIONS with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material • Do not charge or use the battery pack in explosive Regulations (HMR) actually prohibit transporting batteries in commerce atmospheres, such as in the presence of flammable liquids, or on airplanes (e.g., packed in suitcases and carry-on luggage) gases or dust.
  • Page 5 areas, it is illegal to place spent nickel cadmium, nickel metal hydride Always unplug the charger from the power supply when there is no or lithium ion batteries in the trash or municipal solid waste stream battery pack in the cavity. Unplug the charger before attempting to and the RBRC program provides an environmentally conscious clean.
  • Page 6 Chargers Minimum Gauge for Cord Sets Volts Total Length of Cord in Feet (meters) Your tool uses a D WALT charger. Be sure to read all safety Ampere Rating 120 V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7) instructions before using your charger. Consult the chart at the end of this manual for compatibility of chargers and battery packs.
  • Page 7: Charge Indicators

    Charge Indicators Important Charging Notes This charger is designed to detect certain problems that can arise. 1. Longest life and best performance can be obtained if the battery Problems are indicated by the red light flashing at a fast rate. If this pack is charged when the air temperature is between 65 ...
  • Page 8 5. The battery pack should be recharged when it fails to produce COMPONENTS (FIG. 2) sufficient power on jobs which were easily done previously. DO A. ON/OFF button G. Clock button NOT CONTINUE to use under these conditions. Follow the B. Volume knob H.
  • Page 9 TO INSTALL COIN CELL BATTERY (FIG. 3) CHARGER SELECTION SWITCH (FIG. 3, 4) WARNING: Danger of explosion if battery is incorrectly replaced. When the unit is plugged into an AC power FIG. 4 When replacing battery, replace it with the same or equivalent type outlet, this switch (L), located in the battery CR2032.
  • Page 10 Use the right arrow button to adjust the minute in sound from your device through the the same manner. speakers of the DCR015 connect the NOTE: If you do not press a button within 5 seconds, the clock 3.5mm audio cable to the radio's auxiliary programming feature will automatically return to the previous port ...
  • Page 11 WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions. DeWalt electric Power tools...

Table of Contents