Intex 128376NP Manual page 41

(261IO) Sand Filter Pump & Saltwater System with Electrocatalysis Oxidation (14" & 16") ENGLISH 7.5" X 10.3" PANTONE 295U 06/20/2016
SETUP INSTRUCTIONS (continued)
Improper tank valve and clamp assembly could cause the valve and
clamp to blow off and cause serious injury, property damage or death.
6-way valve installation:
1. Lower the 6-way valve over the tank slowly, and ensure the bypass pipe protruding
underneath the 6-way valve fits securely into the center pipe hub (8) top opening (see
drawing 19).
IMPORTANT: There are three hose connection ports on the 6-way valve, ensure the
outlet connection (from filter to the pool) on the valve is facing towards the pool, and
the inlet connection (from motor to valve) is aligned with the motor outlet (see
drawing 20).
2. Remove the clamp bolt, and install the clamp around the tank and 6-way valve flanges, then
replace the clamp bolt and use a phillips screwdriver (not included) to tighten it (see
drawing 21).
8
3. Connect the sand filter interconnecting hose (13) between the 6-way valve inlet and motor
outlet, and insert the electrolytic cell (22) into the 6-way valve outlet. Hand tighten them
securely (see drawings 22 and 23).
13
4. Screw and tighten the flow sensor (21) to the electrolytic cell (22), then plug in the
electrolytic cell line cord and tighten the nut (see drawings 24 and 25).
SAVE THESE INSTRUCTIONS
WARNING
19
WATER
INLET
WATER
OUTLET
22
24
21
22
20
6
22
English
261A
21
23
25
Page 11