Advertisement
Quick Links
Advertisement
Related Manuals for Kogan KATVFSW65LM
Summary of Contents for Kogan KATVFSW65LM
- Page 1 SOLID WOOD TV FLOOR STAND (SUITABLE FOR 45-65" TVS) KATVFSW65LM...
-
Page 3: Safety And Warnings
SAFETY & WARNINGS Read the entire user guide before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, contact your local distributor for assistance. CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury. - Page 4 COMPONENTS A (x1) B (x2) C (x1) D (x1) E Upper bracket F Lower bracket G Plastic cover (x1) H Locking (x1) (x1) collar (x1) I M6x70 Screw (x3) J M6x90 Screw (x1) K D45.5 Washer (x1) L M6x30 Screw (x1) M 4mm M-A M6x14 M-B M8x16...
- Page 5 ASSEMBLY Step 1: Step 2: Loosen the screw and insert part A into part C.
- Page 6 Step 3: • Attach the two assemblies together and secure them in place using an M6x70 Screw (I). • Cover the screw with the plastic cover (G). Note: To remove the plastic cover, press the right side in until the cover pops out. Step 4: Ensure the fastener is vertical and insert a M6x90 Screw (J) into the assembly.
- Page 7 Step 5: • Attach the locking collar (H) to the assembly and secure it into position using the M6x30 Screw (L). • Place the D45.5 Washer (K) onto the stand. Note: Ensure the screw is properly threaded into the hole. The locking collar must be in position before attaching a TV to the stand.
- Page 8 Step 7: • Attach the brackets (E & F) to the rear of the TV and secure them in place using the supplied screws (“M-” set) and washers (M-E). • The cable clips (P-B) will need to be attached to the upper bracket (E). Note: Depending on your TV you may need to install the spacers (M-F &...
- Page 9 Step 8: • Carefully attach the TV to the stand. Enlist the help of a second person to safely carry the TV. • Close the clasp on the lower bracket (F) and tighten the screw (F1). Note: Ensure there is at least 20mm clearance between the bottom of the TV and the stand.
- Page 10 Step 9: • To avoid the TV falling, it is highly recommended to install the anti-fall hardware. • Mark the desired position for the anti-fall bracket (P-C). • Drywall / plaster: Drill a pilot hole using a 3.5mm drill bit and drill. •...
- Page 11 Step 10: Drywall / plaster: Secure the anti-fall bracket (P-C) to the wall using the ST4.8x38 Screw (P-E). Masonry / concrete: Secure the anti-fall bracket (P-C) to the wall using the wall anchor (P-F) and ST4.8x38 Screw (P-E).
- Page 12 Step 11: Using the anti-fall rope (P-A), cable clips (P-B) and rope screws (P-D) secure the TV to the Wall. Note: Ensure there is enough tension on the rope so that the TV will not tip over.
- Page 13 NOTES...
- Page 16 Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...