Table of Contents
Advertisement
If a sender is operating properly and connected to the display with
good wiring, then the display will show the level normally. If the
wiring is disconnected, shorted, or cut, or if the sender panel is
defective, then the display will indicate an error code. The various
error codes are shown in the troubleshooting chapter.
With these diagnostic features and the digital nature of the tank
level sensing technology, it is almost impossible for the system
to indicate an incorrect water level, and in the very unlikely
event it does occur, servicing is greatly aided with the diagnostic
information.
The system also shows the RV battery voltage by measuring the
voltage which powers the display. The voltage is shown with a
resolution of 0.1 volt.
709-LL Manual
Page 5
Advertisement
Table of Contents
