Garnet SEELEVEL II 709-LL Manual page 27

rendering it inoperable and requiring the installer to replace
it. Ensure that that the edges of the cutout are smooth and
that no material is bent outward where it can dig into the
display. Make sure that the cutout is large enough so that
the display can be easily inserted without having to angle it.
There is a ½" border all around the display to cover the edge
of the hole, so if the hole is a bit larger than the minimum
requirement it will still be covered by the display.
2. When fastening the display to the panel, make sure that it is
centered in the hole and not resting on one edge.
3. Non-conductive mounting spacers are available to help
prevent damaging the display. Contact Garnet for further
details.
How to avoid damaging the display or pump switch due to
excessive current:
1. Please be aware that the water pump switch circuit has a
limitation on current draw of 7.5 amps, some large pumps
can draw over 10 amps. These high drain pumps must use a
relay or the display console printed circuit will overheat and
damage the display permanently.
2. If the 12V supply line from the electrical panel does not have
a 7.5 amp fuse rating, please be sure to install the supplied
fuse holder with a 7.5 amp automotive style fuse inline on the
+12V red wire.
709-LL Manual
Page 27