Summary of Contents for Garnet SeeLevel Special 807-ICE 05
Page 1
Remote Display MODEL 807-ICE 05 MANUAL IMPORTANT OPERATOR INFORMATION DATE INSTALLED: _______________________________________________________________________________ UNIT NUMBER: _________________________________________________________________________________ COMPARTMENT: _______________________________________________________________________________ DISPLAY CALIBRATION UNITS (e.g. inches, gallons): ___________________________________________ MINIMUM TANK READOUT: ___________________________________________________________________ MAXIMUM TANK READOUT: ___________________________________________________________________ FULL SCALE ANALOG CALIBRATION VALUE: ___________________________________________________ NOTES : _________________________________________________________________________________________ _________________________________________________________________________________________________ _________________________________________________________________________________________________ _________________________________________________________________________________________________...
CHAPTER 1 - INTRODUCTION ongratulations on purchasing the Garnet Instruments Model 807-ICE 05 S ™ Remote Display. The 807-ICE 05 PECIAL compliments the 808-P2 or 810-PS2 gauges by providing an ad- ditional volume readout in the cab of the truck.
CHAPTER 2 - FEATURES OF THE 807-ICE 05 he 807-ICE 05 has been uniquely designed for specific applica- tions and with specific features: Standard SeeLeveL Remote Display Features 1. The signal between the 808-P2 or 810-PS2 display and the 807 is digitally encoded so the signal line can be connected using a standard 7 pin trailer plug.
CHAPTER 3 - WIRING DIAGRAMS HE 807-ICE 05 has been designed for easy installation with your 808 or 810 series S L ™ gauge. Installation instruc- tions for the gauge were supplied with the equipment, and are available online at www.garnetinstruments.com The 807-ICE 05 Remote Display is easy to install: 808-P2 Wiring Diagram...
CHAPTER 4 - DISPLAY PROGRAMMING he 807-ICE 05 display shows the tank level by repeating the information shown on the 808-P2 or 810-PS2 gauge. The 0-5V analog output is calculated from the display level with a 0V output corresponding to a display level of zero, and a 5V output corre- sponding to the full scale level programmed into the 807 display.
Page 7
8. If the full scale calibration is below 128, the display will be un- able to calculate a valid calibration, and will show cErr (cali- bration error) after a few seconds. The existing calibration will be retained, and the display will return to normal operation. To view the existing calibration: 1.
CHAPTER 4 - TROUBLESHOOTING GUIDE Error conditions: 1. If the display is not receiving any signal from the 808-P2 or 810-PS2 gauge, it will show no S and the analog output will go to zero. 2. If the display receives corrupted data, it will show Err and the analog output will go to zero.
Alberta, T8A 4G7. Returned warranted items will be repaired or replaced at the discretion of Garnet Instruments. Any Garnet items under the Garnet Warranty Policy that are deemed irreparable by Garnet Instruments will be replaced at no charge or a credit will be issued for that item subject to the customer’s request.