Using The Dolby ® Digital Dynamic Range Control Feature - Toshiba 58L9300UC User Manual

120
Picture and Sound Controls
Adjusting the audio
3 Press the p / q (arrow) buttons to select Auto or Manual.
Auto:
Manual: You can manually adjust the audio signal timing to meet
4 Press the EXIT button.
Delay Adjustment
1 Press the SETUP button.
2 Select Sound > Digital Audio Output > Delay Adjustment and
press the OK button.
3
Press the t / u (arrow) buttons to adjust the audio signal timing (0 –
250ms) to meet the video signal timing.
4 Press the EXIT button.
NOTE
v
v
v
v
v
v
Using the Dolby
You can further compress Dolby
dynamic range so you can switch from digital to analog broadcasts at the
same dynamic range.
1 Press the SETUP button.
2 Select Sound > Dynamic Range Control and press the OK button.
3 Press the p / q (arrow) buttons to select On.
This mode automatically adjusts the audio timing to meet
the video timing.
The time lag might be large between the image and sound
depending on the connected equipment (amplifier etc.). In
that case, select Manual.
the video signal timing.
This feature is grayed out when Audio Delay is in Auto.
A time lag will occur when the video signal or audio signal is changed.
Adjust the timing accordingly.
When adjusting the timing, turn down the volume of the AV equipment
used as far as possible.
Depending on the equipment, noise etc. may occur when the signal is
changed.
Depending on the connected equipment (amplifier, etc.), adjustment
may not be possible.
When the optical audio output setting (Auto t PCM) is changed, it
may be necessary to adjust the timing again.
Do not use other than for audio output from the AV amplifier, etc.
(Malfunction may occur)
®
Digital Dynamic Range Control feature
Get other manuals https://www.bkmanuals.com
®
Digital and Dolby
®
Digital Plus