Table of Contents
Advertisement
Example of improper setup: The computer has the IP address
❖
192.168.1.100 with the Subnet mask 255.255.255.0, the TV has the
IP address 192.168.0.101 with the Subnet mask 255.255.253.0; they
are on different subnets.
Unstable network connection.
When using a wired home network connection, unplug the LAN cables,
and then reconnect them.
When using a wireless home network connection:
Reboot the router:
❖
1
Remove AC power from the router and the television for
approximately one minute.
2
Reconnect AC power to the router.
3
Reconnect AC power to the television and turn it On.
4
After approximately two minutes, check connection stability.
Connect with LAN cables, if possible, and check connection
❖
stability.
Repeat the wireless network setup procedure and check connection
❖
stability.
The media server name is not displayed.
The LAN cables, if used, are not connected properly, see
TV to a home network with an Internet connection - wired" on page
The WLAN, if used, is not configured properly.
The network setup on the Server is incorrect. Make sure both the media
server and TV are using the same network type (DHCP/manual) and have
compatible network settings.
Too many devices are connected. You cannot connect more than 32
sharing devices at one time.
The media server is not turned On.
The "server" is not a media server device.
Check the firewall and streaming settings on the media server.
Wireless network problems
Check that the router/AP (Access point) power is On.
After starting wireless network setup, confirm that the network is
configured properly by performing the network connection test, see
"Network Connection Test" on page
Get other manuals https://www.bkmanuals.com
Troubleshooting
Network problems
132.
177
"Connecting the
47.
Advertisement
Table of Contents
