Winplus JUMP STARTER PRO User Manual page 9

JUMP STARTING CONT.:
NOTE: If the engine dies shortly after it has been jump started, or
as soon as the jumper cables are disconnected, it probably means
the vehicle charging system is not working (bad alternator, voltage
regulator, wiring problem, or loose/dirty battery cables). Please seek
professional help from an auto mechanic to find the root cause of the
problem.
The Jump Starter Pro may not work correctly for vehicles that require
remote battery jumper locations (e.g.: battery located in trunk or other
location). Please consult the owner's manual for your vehicle.
Polarity Protection Circuit Status
Status (Light & Sound Indicator)
Red Light Green Light
Solid LED On
Sound
None The car battery is ready for jump start.
None The Jump Starter needs to be charged.
None The car battery is ready for jump start. If
the indicator doesn't turn solid Green, the
car battery voltage is higher than the jump
starter. You can still jump start your battery,
but may need to charge your jump starter.
Beeping Disconnect the jumper cable from the car
battery and jump starter. Either the car jump
start is complete or there is a connection
problem.
None This status shows after 30 seconds time out.
Disconnect the jumper cable from the car
battery and jump starter to reset. Reconnect
the jumper cable to jump start the vehicle.
None Please contact Winplus for troubleshooting.
Flashing LED
9
Status Meaning:
LED Off