Winplus JUMP STARTER PRO User Manual page 8

JUMP STARTING CONT.:
6. You now have 30 seconds to start your vehicle before the
jump starter times out to prevent the vehicle battery from
reverse charging the unit. If it does not crank or cranks very
slowly, wiggle the jumper connections to make sure they are
making good contact. Wait 60 seconds before trying to
start your car again. Each new jump start attempt requires
disconnection of both clamps from the car battery and
reconnection. The engine should start if there are no other
problems (such as a bad starter or ignition circuit problem).
Do not attempt to jump start the vehicle more than 3 times
with the Jump Starter. If the vehicle fails to start after 3
attempts, it is likely due to alternative reasons and should be
checked by an auto mechanic.
7. As soon as the engine starts, the indicator box on the BLACK
clamp will blink red and beep to let you know it is ok to
disconnect.
8. Please disconnect the jumper cables from your car within 30
seconds. First remove the RED/POSITIVE (+) clamp and
then the BLACK/NEGATIVE (-) clamp.
9. Do not allow the metal ends of the jumper cables to touch each
other or the
Now unplug the
jump starter. This will reset the jumper cable. In 10
seconds the jump starter will power off automatically.
10. Keep the engine running for 20 to 30 minutes, or drive
the car to recharge the battery.
RED
clamp to touch anything metal on the car.
BLUE
end of the jumper cable from the
8