Jump Starting - Winplus JUMP STARTER PRO User Manual

LED FLASH MODE / HAZARD LIGHT
a) Press the flash button once for the
spotlight in front to flash. Press again for the
spotlight and lantern light to flash.
b) Press the hazard light button once to turn
on the hazard light.

JUMP STARTING:

To jump start the 12-volt vehicle battery, put the
vehicle in park (neutral if the vehicle has a manual
transmission) and engage the emergency brake.
Locate the battery for the vehicle and follow the
steps listed below.
Jumper cables are color coded,
POSITIVE (+) and BLACK for NEGATIVE (-).
DO NOT mix up the cables or allow the metal
ends to touch each other as this may damage the battery,
charging system and/or electronics on a vehicle.
1. Press the power button on the Jump Starter once and check
that the power level indicator is 3 solid lights (51%) or higher.
2. Take the BLUE
jumper cable and plug it into the
power bank jump start socket
which is located underneath the
black cover.
RED
end of the
6
for
Red
b
a !
Black
Red
Black