Advertisement
1-Safety information
WARNING!
Maintenance / cleaning
Clean the lint filter and the condenser fi lter after each pro-
gramme (see CARE AND CLEANING).
Do not use water spray or steam to clean the appliance.
Do not use industrial chemicals to clean the appliance.
If the supply cord is damaged, it must be replaced by the manufa-
cturer, its service agent or similarly qualified persons in order to
avoid a hazard.
Do not try to repair the appliance by yourself.If a repair is
needed, please contact our customer service.
Installation
Ensure put the machine in a place which allows opening the door
fully. Do not install the tumble dryer behind a lockable door, a
sliding door or a door with hinges on the opposite side of the
tumble dryer door as this limits the full opening of the door.
Install the appliance in a well-ventilated, dry place.
Never install the appliance in a damp outdoor, or in an area
which has the risk of water leakage such as under or near a sink
unit. Once a water leakage happened, cut power supply and allow
the machine to dry naturally.
Install or use the appliance only in a place where the temperature
is above 5 °C.
Do not place the appliance directly on a carpet, or close to a wall
or furniture.
Do not expose the appliance to any frost, heat or direct sunlight
or around any heat sources(e.g. stoves, heaters).
Make sure that the electrical information on the rating plate
aligns with the power supply. If it does not, contact an electri-
cian.
Do not use multi-plug adapters and extension cables.
Make sure not to damage the electric cable and the plug. if it is
damaged, have it replaced by an electrician.
Use a separate earthed socket for the power supply which is easy
access to after installation. The appliance must be earthed.
Only for UK: The appliance's power cable is fi tted with 3-cord
(grounding) plug that fi ts a standard 3-cord (grounded) socket.
Never cut off or dismount the third pin (grounding). After the ap-
pliance is installed, the plug should be accessible.
6
EN
Advertisement
