Service; Appliance-Specific Safety Instructions For Electric Staple Guns; Before Use; Filling The Magazine - Parkside 385147 2107 Translation Of The Original Instructions

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety
instructions for electric staple
guns
■ Always check that the power tool contains
staples.
Careless handling of the staple gun can lead to
unexpected ejection of staples which could
cause injuries .
■ Never aim the power tool at yourself or other
people in the vicinity. Unintended triggering
will cause a staple to shoot out, which can lead
to injuries .
■
Do not activate the power tool until it is
pressed firmly against the workpiece . If the
power tool is not in contact with the workpiece
the staple can rebound off the fastening point .
■ Disconnect the power tool from the mains or
battery if a staple becomes jammed in the
power tool. If the staple gun is connected to a
power source, it could be unintentionally acti-
vated while removing a jammed staple .
■ Be careful when removing a jammed staple.
The system may be live and the staple could be
forcefully ejected while you are attempting to
unblock the jam .
■ Never use this staple gun for fastening elec-
trical cables. It is not suitable for the installation
of electrical lines, can damage the insulation of
electrical cables and thus cause electrical
shocks and increase the risk of fire .
PET 25 C3
WARNING!
■ To avoid risks, damaged mains cables of the
appliance should be replaced by the manu-
facturer or the manufacturer's customer
service department or a similarly qualified
person .

Before use

NOTE
► Only fill the magazine when the appliance is
switched off! Set the ON/OFF switch
the position "0" and pull out the plug!

Filling the magazine

♦ Squeeze the magazine slider
♦ Pull the magazine slider
magazine of the appliance (see fig . B) .
♦ Fill the magazine
(see fig . C) .
♦ After filling, push the magazine slider
into the magazine
hear and feel it click into place .
NOTE
► When filling with nails, use the right shaft
(as shown in fig . C) . Ensure that the nail
heads are always at the top .
► Note the maximum fill level of approx .
85 staples or approx . 75 nails .
► If the red line on the front of the magazine
slider coincides with the marking of the fill
4a
level indicator , then the magazine is
8a
empty .
to
(see fig . A) .
out of the
with staples or nails
back
as far as the stop and you
GB │ IE │ NI │ 5 ■