Yamaha ARIUS YDP-184 Owner's Manual page 104

Keyboard Stand Assembly
2-1.
Align the screw holes on the upper side of B
with the bracket holes on D and E, then attach
the upper corners of B to D and E by finger-
tightening two thin screws (4 × 12 mm).
2-2.
Secure the bottom end of B using four
tapping screws (4 × 20 mm).
2-3.
Securely tighten the screws on the top of B
that were attached in step 2-1.
3.
Mount A.
Be sure to place your hands at least 15 cm away from
either end of the main unit when positioning it.
Align the screw holes.
At least 15 cm
CAUTION
• Be extra careful not to drop the main unit or let your fingers
be pinched by it.
• Do not hold the main unit in any position other than the
position specified above.
104
YDP-184 Owner's Manual
A
4.
Secure A.
4-1
4-1.
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally (as seen from the front).
4-2.
Secure A by tightening six thick screws (6 ×
20mm) from the front.
5.
Connect the pedal cord and AC
adaptor.
5-5
A A
A A
4-2
5-1
5-3
5-2