Emerson Bettis XTE3000 Maintenance Instruction page 37

Table of Contents

Advertisement

Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
Hardware 8
Hardware 9
Hardware 10
Hardware 11
Hardware 12
Hardware 13
°"
Alarm "Hardware n
No communication between the bus card and base card.
Turn off the power and check that the base card is equipped with the correct bus interface
card. Cycle power on the actuator and check the following parameters in the "RESTRICTED"
menu routines:
HW config: should be set to the "option" corresponding to the bus interface
present on the base card.
Bus protocol: should be set to "I24" or "I20" according to the relevant bus protocol
instruction manual.
Reserved. Not used for XTE3000.
Reserved. Not used for XTE3000.
No communication between the bus (Profibus redundant card) and logic card. Turn off the
power and check that the base card is equipped with the correct bus interface card.
Cycle power on the actuator and check the following parameters in the "RESTRICTED"
menu routines:
HW config: should be set to the "option" corresponding to the bus interface
present on the base card.
Bus protocol: should be set to "I24" or "I20" according to the relevant bus protocol
instruction manual.
No communication between the encoder and logic card.
Turn off the power and check the encoder cable; if damaged, it must be replaced.
Cycle power on the actuator to check if the problem is corrected.
If the problem is not corrected, replace the Encoder. Cycle power on the actuator to check if
the problem is resolved.
If the problem is still not corrected, replace the Logic Card. Cycle power on the actuator to
check if the problem is resolved.
Encoder damaged or incorrectly configured.
Turn off the power and check the mechanical condition of the encoder. If damaged, it must
be replaced. Cycle power on the actuator to check if the problem is corrected.
If the problem still not corrected, replace the Logic Card. Cycle power on the actuator to
check if the problem is resolved.
Section 5: Alarm "Hardware n°"
February 2022
33

Advertisement

Table of Contents
loading

Table of Contents