Emerson Bettis XTE3000 Maintenance Instruction page 25

Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
Table 15.
Obj n°
1205
1215
1225
Table 16.
Obj n°
1206
1216
1226
Table 17.
Obj n° Value Function
51
55
56
53
54
52
59
60
57
58
°"
Alarm "Configuration n
AS10 Relay
Value Function
Open limit AS10 condition
20 AS10 position%
Make AS10 contact
AS11 Relay
Value Function
Open limit AS11 condition
20 AS11 position%
Make AS11 contact
2-Speed Timer
Off Status
2 On time in closing
2 Off time in closing
0 Start position in closing
100 Stop position in closing
Off Status
2 On time in opening
2 Off time in opening
0 Start position in opening
100 Stop position in opening
Section 4: Alarm "Configuration n°"
Actuator Setup
Description
Open limit, close limit, position >=%, position <=%, closing,
opening, running, blinker, mid-travel, local selected, remote
selected, local stop on, ESD/PST-efs, manual operation
(handwheel), motor over temperature alarm, over torque
alarm, over torque alarm in OP, over torque alarm in CL, valve
jammed alarm in OP, valve jammed alarm in CL, valve jammed
alarm, low battery alarm, warnings, mid travel alarms, EFS
in manual, PST failed, Mains only As8, EFS mid-travel, INTER/
PST-icon, EFS coil OFF
Position% if AS10 condition is position >=% or <=%
Make, break
Actuator Setup
Description
Open limit, close limit, position >=%, position <=%, closing,
opening, running, blinker, mid-travel, local selected, remote
selected, local stop on, ESD/PST-efs, manual operation
(handwheel), motor over temperature alarm, over torque
alarm, over torque alarm in OP, over torque alarm in CL, valve
jammed alarm in OP, valve jammed alarm in CL, valve jammed
alarm, low battery alarm, warnings, mid travel alarms, EFS
in manual, PST failed, Mains only As8, EFS mid-travel, INTER/
PST-icon, EFS coil OFF
Position% if AS11 condition is position >=% or <=%
Make, break
Actuator Setup
Description
Off=disable timer in CL, on=enable
From 2 to 200
From 2 to 200
% of position where timer operation starts. From 0 to 100
% of position where timer operation ends. From 0 to 100
Off=disable timer in OP, on=enable
From 2 to 200
From 2 to 200
% of position where timer operation starts. From 0 to 100
% of position where timer operation ends. From 0 to 100
February 2022
21