Technical Data; Installation - Progress PHN1310 User Manual

14 progress
Problem
The cooking zones do not op-
erate.
The appliance does not oper-
ate.
The appliance does not oper-
ate.
The oven lamp does not oper-
ate.
Steam and condensation col-
lect on the food and in the
oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

TECHNICAL DATA

Voltage
Frequency

INSTALLATION

Warning! Refer to "Safety information"
chapter.
Building Under
Warning! Only a qualified and
competent person must do the
installation of the appliance. If you do
not contact a qualified or competent
person, the guarantee becomes invalid
if there is damage.
• Before you install the appliance, fit it with
the applicable hob from the table.
Type
PEM 6000 E
PES 6000 E
PES 6060 E
Possible cause
The appliance is not activated.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the oven for
too long.
Maximum power
6000 W
5800 W
7600 W
Refer to the user manual for the hob.
Activate the appliance. Refer to
the chapter "Daily use".
Do a check of the fuse. If the
fuse is released more than one
time, contact a qualified electri-
cian.
Replace the oven lamp.
Do not keep the dishes in the
oven for more than 15 - 20 mi-
nutes after the cooking ends.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity.
.........................................
.........................................
.........................................
230 / 400 V
50 Hz
560
570
Remedy
540
20
590
594
7