Lighting The Burners; Saucepans - Pelgrim NF925B Manual

Lighting the burners

Electrical spark ignition
Turn the control knob anti-clockwise to
maximum and press it at the same time. Sparks
appear around the burner which then ignites.
The gas flame can be smoothly adjusted from
high to low. If the burner fails to light after
repeated attempts, check to ensure that the
burner cap is properly positioned.
Thermocouple protection
This appliance is fitted with a thermocouple.
This is a thermoelectric protection system. It
ensures that the gas tap is closed if the flame
goes out. Press the desired control knob and

turn it to the left to the maximum setting. Press
the ignition until the burner ignites. Hold the
control knob pressed in for 5 seconds.

Saucepans

The recommended pan sizes are:
For the wok burner minimal 28-34 cm;

For the rapid burner minimal 22-26 cm;

For the semi-rapid burner minimal 16-20 cm;

For the simmer burner minimal 12-14 cm.

Tip
When cooking without a lid, energie is
wasted.
Clean saucepans absorb heat more efficiently.
Cooking timer (NF 930)
fig. 3
The timer only gives a signal when the time
has elapsed.
Turn the timer knob clockwise all the way

to 55 minutes. This way you tighten the
spring.
Turn the timer knob back (anti-clockwise)

to the desired time.
Wrong :
A great deal of heat is
lost along the sides of
the saucepan.
fig. 4
Right :
The heat is evenly
distributed over the
base of the saucepan.
fig. 5
fig. 6