Fagor IO-DWS-1497 Instruction Manual page 87

INSTALL THE APPLIANCE
PLACE YOUR APPLIANCE
When choosing the place of installation, make sure you will be able to easily load and remove
dishes and utensils from the dishwasher.
Do not place the appliance in a room where the temperature can fall below 0°C.
Before installing unpack the appliance following the instructions on the packaging.
When you move the appliance do not handle it by the door or control panel.
Leave some room on all sides to have convenient access to the dishwasher when cleaning.
Make sure that when you set the dishwasher you do not crush the water supply and drain hose.
Also, make sure that the appliance is not places on the power cord.
Level the appliance using the adjustable legs. Proper level ensures trouble-free opening and closing
the dishwasher doors.
If the dishwasher door will not close properly, check that the appliance stands firmly on the floor, if
not, adjust using the adjustable legs.
WATER SUPPLY CONNECTION
Make sure that domestic water supply system is suitable for the dishwasher. It is recommended to
install a filter in the water supply line to avoid damage to the appliance due to impurities (such as
sand, clay, rust, etc.) that occasionally occur in water. This will also prevent accumulation of sedi-
ment after dishwashing.
WATER SUPPLY HOSE
Do not use the water supply hose from the old dishwasher. Use the new water supply hose
provided with the appliance. Before connecting, rinse the hose with water. Connect the
water supply hose directly to the water feed valve. The domestic water system pressure
should be at least 0.03 MPa and up to 1 MPa. If the water pressure exceeds 1 MPa, install
pressure reducing valve.
When the connection is ready, open the valve completely and check for leaks.
For safety reasons, close the water supply tap after every wash.
87