Advertisement
Responses sent from the follower to the initiator shall have the following format:
(u;www:x=z) [CR] [LF]
Where:
● '(' and ')' indicate the start and end of the command data. If these characters are present,
the command processor shall assume that "valid" command data is present in the command
string. If these characters are not present in the command, the command processor shall
assume the data is not valid command data and ignore it.
● "u;" indicates the response code. This is only used by followers responding to a valid
command received. For any response code other than 0, the follower shall echo back the
command received rather than filling in the fields listed below. The following response codes
can be used:
o 0 = Command successfully processed
o 1 = Unknown command code
o 2 = Invalid operator
o 3 = Destination parameter not supported
o 4 = Setting not available
o 5 = Setting value not available
o 6 = Setting value not supported
o 7 = String too long
o 8 = Command not supported in standby mode
o 9 = Invalid parameter
o 10 = Error processing command
o 11 = Password not entered
● "www" indicates the command code sent by the follower. This field is case insensitive (i.e.
"PWR", "pwr" and "PwR" should all be treated as "PWR").
● ":x" is the destination parameter. This is an optional parameter that indicates which memory
the response is referencing. This parameter is reserved and shall not be used at this time.
● "z" is the new value (for set/increment/decrement commands) or the current value (for get
commands) for this parameter. It can have one of two formats:
● Integer value: Any positive or negative number (example: 100)
● String value: Any string surrounded by double quotes (example: "This is a string")
● "[CR]" is the ASCII carriage return key (0x0D).
● "[LF]" is the ASCII line feed character (0x0A).
Planar PS Series 4K Displays RS232 User Manual
020-1389-00C
RS232 Codes
Page | 5
Advertisement
