Table of Contents
Advertisement
300S Softlight LED Luminaires
CLEANING AND CARE
WARNING! All cleaning should be performed with power completely removed from the luminaire. Never
removeprotective covers when luminaire is powered. Wear appropriate protective eye wear and gloves when
cleaning the fixture. All service and maintenance, other than described herein, should be performed by a qualified
technician or Authorized Service Center.
1. Special Cleaning and Care Instructions
Being a solid-state fixture, and unlike most fixtures, the 300S Softlight LED Luminaire requires very little
routine maintenance by the user. This section covers portions of the luminaire that can be removed for cleaning.
The 300S Softlight LED Luminaire special care when it comes to cleaning front lens assembly. Additional care
needs to be taken with the plastic components because they are much easier to scratch or damage than glass.
The following is a list of cleaning materials required to care for your 300S Softlight LED Luminaire:
Lint free lens tissue
Lint or powder free gloves
Reagent grade isopropyl alcohol*
A mild soap solution.
Note: *Reagent grade isopropyl alcohol is good to use on the 300S Softlight LED Luminaire plastic optics with
anti-reflection coatings.
if the lens is still dirty after using isopropyl alcohol, for instance if fingerprints or oil is just redistributed and not
cleaned off the optic, then a mild soap and water solution can be used to gently wash the lens. Repeat the cleaning
with isopropyl alcohol to eliminate streaks and soap residue.
W ARNING! Under no circumstances should ammonia based cleaners acetone or other harsh solvents be used on or
near the 300S Softlight LED Luminaire These types of cleaners or solvents can permanently damage the
optics or housings of the fixture.
If you have any questions regarding the use or care of your 300S Softlight LED Luminaire
Strandlighting technical support or your local Authorized Dealer.
2. Front Diffusers Cleaning
To clean the front diffusers:
.
Step 1
Disconnect luminaire from power and allow to cool completely
.
Step 2
Apply a small amount of reagent grade
.
Step 3
Wipe all debris dirt fingerprints etc from diffusers
.
Step 4
Using a second lint free lens tissue wipe off any alcohol residue
3. Service and Maintenance
For all other service and maintenance issues
Service Center.
W ARNING! Disassembly other than as described herein
product warranty Contact your local Strandlighting office or an Authorized Service Center for technical support and
service.
.
,
,
-
(
.
-
,
isopropyl alcohol to lint free lens tissue
,
.
.
,
,
please contact your local Strandlighting office or an Authorized
),
alterations unauthorized service etc will void the
Installation & User's Manual
,
.
-
.
.
,
,
CLEANING AND CARE
,
please contact
.
23
Advertisement
Table of Contents
