Replacing the power button with fingerprint reader
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE:
Applicable only for computers that are shipped with fingerprint reader.
Procedure
1. Place the power button or power button with fingerprint reader into the slot on the palm-rest and keyboard assembly.
2.
NOTE:
This step is applicable only on the computers that are shipped with fingerprint reader.
Open the power button cable connector latch, reconnect the fingerprint-reader cable and close the latch.
3. Replace the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
Post-requisites
1. Replace the
display
assembly.
2. Replace the
wireless
card.
3. Replace the
I/O
board.
38
Removing and installing components
computer. After working inside your computer, follow the instructions in
After